- Racing Beat muffler
- Stainless exhaust?
- mild street port
- not worth doing
- bridge ported 12a at seven stock 5
- 12a porting ?
- Porting and Nitridied Side Housings
- Hurley Apex seals
- Ianetti Apex Seals
- Turbo setups and HP
- rotary valves
- Engine Rebuild
- sva emmissions
- Hylomar Sealant
- Fd/Fc Oil system?
- Triple rotor, N/A
- Costs of an FD Engine Build
- Powerflow Exhausts
- Parts Needed
- Series IV RX7
- Good link on porting
- Best ECU?
- 2nd Gen Turbo 2 BOV (dump valve)
- Turbo Problems
- Apexi AFC
- urgent info required
- 20B FD conversions..
- ecu retard function
- Down pipe/Mid pipe.
- Thanks for the replies.
- ECU codes - how do you pull them?
- Detonation
- It"s arrived.
- Broken engine!
- Can Rotaries Suffer Bore Wash?
- Now thats a port !
- Cold air induction
- Untracable water leak on stopping - suggestions?
- Cheap EFI
- Please Help Everyone
- Another turbo bites the dust...
- how far can i stretch my egi? :confused:
- Haltech and injectors query
- What ecu is this??
- FD Engine rebuild parts list
- plug gap?...
- Speed Pro ECU?
- Turbo II - how do I tell if it is working ?
- Information on Ceramic Apex Seals
- Good information on Turbo's
- Charge Relief Valve (BOV)
- another porting question
- How much ?
- Loan Wideband lambda sensor
- Ianetti Seal Information
- EGI tunning questions.
- Kaput turbos.
- Boost Problems with FD3S
- Boost problems with FC3S
- cool bit of engine dress up....
- engine overheat????
- Turbo boost
- PFC or F CON V ?
- Engine Break In?
- engine rebuild cost
- Racing beat article on 6-port
- Water Leak
- Thoughts on NOS on a rotary
- 900 Bhp???
- Injector Upgrades!
- RX7 Servicing
- 13B Cosmo compared to 13B FD
- Turbo Size's?
- Big thanks to GPA
- Buggered Y pipe?
- Turbo Calculator program
- spark plugs !
- exhaust opinions
- Turbo's, I Think!!!
- Remove And Refit Engine
- All you need to know about Mazda Apex Seals from the new RX-8 book
- ECU/De-limiter
- Abs
- What is?
- Experiences/opinions on intake systems
- Ecu
- Rotor Tips
- Apexi Power FC fitted
- Greddy Rebic Type II
- Idling problem
- RE rebuilders around the London area?
- Engine to exhuast manifold gasket?
- HKS F con fuel and boost
- power fc air fuel ratio
- sparks plugs and induction?
- Low Boost
- Rebuild at home
- air/fuel ratio lean peaks(please look)
- Mapping recomendations
- Boost controller
- Induction Kits
- searching for FC3S stainless steel exhaust
- oil presure/water temp
- Turbo's & Air Pump
- nitrous on an RX7
- HKS FCD installation ??
- Tuning
- What spark plugs for single turbo conversion?
- Hurley rebuild
- Difference between 250BHP and 280BHP??
- Got my new RX7 - Please help with problems!
- B&M KEW VOLT - what on earth is it?
- Which exhausts for 3rd gen RX7 have bung/muffle ability?
- Which header?
- Chuck a Clutch!
- Fitting a greddy turbo timer - What colour is speed wire?
- Boost problem - anyone know where solenoids are?
- Turbo Timers
- Blow Off valves/Dump valves
- dumb question
- Hurrah! my aquamist kit has arrived!
- FD seems to have lost power?
- manifold
- Power FC
- 93 FD - Which Exhaust?
- 0.78 mmhg?
- V-Mount IC/Radiator
- water injection
- good for the road and dragway
- which clutch?
- aftermarket body kits
- Boost Problem Fixed !!
- 11,000mls per engine?
- Tuning tips please
- Thermotec exhuast wrap?
- cat on 92 fd type x
- Emissions how to help please?
- fumes???
- electrical problem
- RX-7 3rd Gen (easy question) : at what revs does each turbo kick in?
- anyone no where the temp sender unit is
- Boost problem - from too little to too much!
- Turbo not keeping it's boost up!!!
- HP estimate needed
- Ceramic Coatings?
- Clear repeaters
- Does anyone have an apexi avcr on your fd,if so please help
- Tuning Stages
- Downpipe
- New engine parts?
- Making it run nice and smooth
- A Bit Worried On Things Too Do
- Setting Timing
- Dump valve hose?
- Need advise...A/F ratio's
- Expensive trip to IKEA (clutch problem)
- Performance cat
- Blitz plugs
- motec
- please post duty cycles
- Rotor tips again
- induction kits
- HKS EVC IV Boost controller installation instructions?
- Fuel Filter/ and waste gate
- Single Turbo
- Enigne Oil Question????
- sudden engine power loss
- re: Garrett TB serie
- Turbo rebuilds/upgrades
- Turbo Cut??
- rolling road and hks fcon.
- Air Pump to Air Box hose
- rotary powered kit car project - help needed!
- Octane for standard ECU
- Twin carbs
- Mineral Oil vs. Synthetic
- Help wanted - pulleys...
- oil in intercooler and intercooler pipe?
- which intercooler?
- advice needed!
- Diff noises
- exhaust restrictor valvue, where can you get them?
- pulley kit.
- Downpipe
- Help!!!cant Pass The Emission For The Mot
- oil change
- more knock problems
- Apexi power FC etc wot to buy?
- Looks like a rebuild sooner than I hoped...
- Help removing my 13B engine
- problems getting 13b running after rebuild
- Apexi
- Turbo
- Huge Problems ( I Think)
- What r the signs the a water seal has gone?
- Trailing Coil
- Signs of a Water seal problem?
- Fuel Cut Defense
- Boost Gauge
- Can it take it ?
- Another Apexi question
- 13B COSMO to FC
- fc commander
- Turbo Question
- Apexi Boost control kit problem
- Why do our engines keep blowing up?
- to4e spec
- how much power ?
- HKS F-CON V anyone ????
- I'm stupid and I need help
- choke cut off
- warming up and cooling down
- boost gauge
- Got some dyno time - what should I look for?
- Turbo conversion - why?
- Multi Rotor
- Displacement
- car starting
- Yellow gunk oil filler cap
- Tuning stages
- I'm confused
- Newbie questions on 3rd gen RX7
- Reasonable level of tuning + cost
- Car tuning information
- Bridge or Street Porting
- System design part 1: initial considerations
- Big turbo!!!
- charge cooler
- Lambda to Air Fuel Ratio Table
- tuning
- Octane Booster
- apexi pfc tuning
- Is it goin to blow up?
- Throttle Positioning
- when will it pop?
- Turbo Timer
- My car wont work
- Spark Plugs
- Plate Lapping?
- Air pump questions
- 88 13b question
- Apexi Guage sensor
- Gauge a reaction *boom boom*
- Another apexi question - power fc this time
- Anyone got a map
- Idleing
- supra v's rx-7
- Apexi Power FC
- up grades?
- downpipe and de-cat