- Complete Hose Replacement (diy).....is it worth it?
- Feed.......Mainly FAO for 20b!
- Single Turbo Help!!!!
- Alternator pulley removal
- Robertio in dead engine shocker :-(
- air filter questions
- smoke on startup, oil in intake
- HKS TO4 wastegate gasket
- Instructions for a Blitz VGTT Turbo timer
- How smooth should the transition of power be between 1st and 2nd turbo's?
- The ultimate rotary gadget !
- how to balance an engine?
- Power FC's
- More questions about PFC's
- Alternator
- Rolling Road Figures for a TII
- injector and fuel pump questions
- What Oil Pressure Gauge ?
- cone air filters
- furthest north
- Intercooler or radiator
- Broken Oil Metering Pump Feed Line
- Pulley Kit
- Oil pressure
- Another Nitrous Question
- Top Feed Injectors
- HKS Twin Cone Fitting
- Why is my car running 15 psi boost
- yes another 1 about the pfc :D`
- Water Injection
- dump valve fitting
- fitting a turbo xs dump valve
- Single turbo jargon
- any locals want to help :D
- plenum connections for boost control
- BOV and Induction Kits
- Turbo conversion now smoking ~ HELP!
- european vacuum hose diagram
- possible stupid idea
- HKS downpipe for single turbo
- Vacuum Check valves
- Steel intake pipes
- apexi ecu fuel cut
- Boost Controllers
- twin turbo tuning
- Is this BOV fitted correctly
- This is really strange, anyone had this happen?
- Rebuild time!!
- mot
- How much to map an Apexi Power FC?
- BMW MIni Cooper question
- wiring
- V8 into FD?
- Anyone used JPS Motorsport in Milton Keynes ?
- additives
- Food for thought
- Rebuild Cost
- Totbiii
- garrett t68
- Heat Sheild
- Fan Belt Size?
- Exhaust Manifold
- TOTB III The nightmare!!!
- standard BHP?????
- Where To Start
- Commander Confused
- possible engine/performance figures
- What's the difference between street and racing apex seals?
- Down pipes
- apexi electronics...mo' money
- price for new cat? (3rd gen)
- Inlet Temps?
- Engine is out....
- Coolent and air bubble help
- Wheres my woosh
- porting and exhausts
- Decent clutch for an Egi
- How much power!?
- Does this look ported? (pics inside)
- Greddy Oil Coolers for FD3S
- gearbox difficulty
- 20b conversion
- jdm exhaust
- Tip Seals for Gen 1 12A
- Elford jet sizes
- ECU advice
- Fuel controller thingy...
- Oil coolers
- Triple rotor RX
- RE Amemiya ECU
- gt35/40 turbo ideal boost
- My t51r experience
- Exhaust/leaness issues
- Mines ECU
- Collapsing intake pipe?
- Good Price?
- Does anyone regocnise this intake kit ?
- Mystery strut
- Santa pod today
- power figure from OZ on single turbo on Dyno Dynamics rollers
- Exhaust Temp Light
- HKS Intercooler
- Rear Diff Ratios...
- Tranny....
- Coolant leak (yet again)
- 12 Rotor Engine???
- Tuning in Wales or close to it !!.
- First RX7 gets into the 10's
- holset turbo help?!?
- Air pump/magnetic clutch problem
- Another Air Pump Problem
- Advice+pictures required for FMIC fitting
- Non sequential turbo set up help please
- Fuel System Upgrade
- Simple Blitz BOV yes/no question
- Exhaust Repairs
- Group Buys - 2nd Gen Dual Alternator Pulley
- Turbo timers
- What clutch??
- Oil Injectors/Single turbo
- Hissing blow off valves!
- blitz
- strange bubbling noise
- Body Kits
- Installing a boost gauge ????
- Apexi FC
- what do you wreckon??????
- Help/advice needed
- Problem with starter!
- Single Turbo?
- Rebuild question...
- fuel regulator
- BOV Tuning to avoid killing turbo
- Split water hose or water seal?
- Turbo Resurrection
- Maximum safe oil temp
- Help sourcing battery cable and gasket paper!!??
- turbo removal
- Gearbox/Driveshaft
- Non sequential conv, help identifing parts please.
- ps oil pump
- Boost
- fuel?
- Coolant Cap
- Help!
- fwhp and rwhp in relation to other cars
- Exhaust Port Sizes?
- Injector Imp?
- Making a standard (relatively) FD bullet proof.
- !!HELP!! hot starting problem
- 20b ECU Upgrade
- collant light
- Apexi SAFC
- Re-a air filter question
- sick rx-7
- an ignition cut rev limiter
- Blitz SBC Spec S Boost controller
- FD Uprated intercooler - suggestions please
- 12a engine in a 929 coupe
- Fear of Detonation!
- Cpl
- Tuning A Apexi Ecu
- turbo spooling up
- fitting a BOV
- Single Turbo?
- FMIC Hard pipes required what type?
- Lads gota beat a 320bhp GT4 ST205,
- pfc, altering injector size
- Apexi intake install
- help
- Is This To Small????
- flywheel removal
- Minimum mods for 325whp?
- measuring air intake temp on stock ecu ?
- HP rating for a turbo II gearbox?
- injector question??
- Supercharger in a FD3
- 8bit ecu to later 16bit ecu
- Knock sensor connector location?
- Data logging
- Power Fc
- Maximum power in a rotary streetcar?
- Backfiring under full boost
- pfc boost controller ?????
- Sos
- Rebuild advice...please help!!
- Grind whilst idleing
- Ideal turbo specs?
- 12A Elford Turbokit
- Rx8 plugs in older engines
- Low Secondary Boost
- boost dropping off
- Water Temp sensor
- Oil By Pass Thermostat! Advice Please,
- Rotary Air flow
- injector placement.
- Mazdaspeed clutch discs...
- rebuilding (with pics and bad gramar)
- Intercooler Upgrade
- Water injection system, yes or no
- My new project Rotary Drag Car
- Was overheating, what do you think???
- Post rebuild protocol?
- EGT's????
- Rx7 Fan Belt??
- O ring probs
- are switchable turbo's possible?
- lumpy idle
- Problem with my Microtech?
- external wastegates
- Trying to stall?
- Confused About Precat
- Miss at low revs??
- Early warning signs
- urgent help overheat
- power fc tuning
- Exhaust Over Heating
- Boost Guage
- Speed Limiter !!
- Octane Boosters - Good or Bad
- Dropping an FD engine in an FC
- Turbo Manifold Pipe
- blitz power meter
- lumpy '93 FD3
- ECU Upgrades
- When is it warm?
- HKS Induction Kit
- A-Pillar pod thingys
- overheat again!!
- Apexi PFC and battery disconnection
- Turbo servicing
- Intercoolers
- seires 1 carb
- MoTeC support for rotaries in the UK
- Type R Bathurst 2.8
- Cant Turn Car On HELP PLZ!!!
- chirping from engine! ??
- throttle body size?
- How hard to install a PFC ????
- alternative radiator positions?
- intake pipes
- How far?
- clutch
- N2O in an Egi
- Performance of F3DS
- Apexi GT Spec Intercooler
- Heat light stays on after fitting PowerFC
- What Oil Do u guys use??
- Which pipe for dump valve.....
- Intercooler upgrade help!!