- Are all Apexi PFC Commanders the same ?
- loss in power on FD lighty modded
- end float?
- Electrical problem with Chargelight and warninglighs for Water/EngPress
- Ready for fun
- power fc commander
- confused with bushes, differences between polybushes and mazda items
- Removing exhaust housing on stock tubs
- Power output from a Rotary engine as mileage increases
- Aluminium AST Cap - which one?
- Tial wastegates
- Devils water injection kit
- Methonol Injection
- fmic's on ebay
- What to do next?
- Hose Replacements
- Waterpump/Alternator pulley set
- hesitation/loss of power after 0.2bar boost
- OMP Lines?
- rebuild/fitting single turbo
- mobile rx7 mechanics
- Thermal/ insulation wrapping
- keeping the noise down
- Wierd rev's drop on clutch use
- Intercooler Question
- Air Intake Question
- Whos got a Mongoose exhaust?
- Been offered a T04 Turbo...........
- SCOOT bonnet
- Performance/Longevity differences between apex seals
- whats tha ACV?
- Best exhaust system for a 1999 3rd gen RX7?
- Flooded - Help
- Fuel cost
- One tub per rotor
- IC Sprays
- First set of maintainence to do!
- loss of power and spluttering under accelleration
- The dreaded boost probs (again!)
- 100% compression?
- acv removal
- Greddy Spec-M FMIC Fitting instructions
- apeci intakes
- Paths to more power - 400hp
- T04e turbo
- oil coolers
- Air con, Go or stay??
- Interior retrimming
- Revolution V-Mount IC
- 1999 Spec Efini Twin turbo's
- Apexi PFC DIY mapping
- To any one with a Blitz Front Mount IC
- Is this a safe Mod??
- Fittin 2xt04 Turbos Opinions Plz
- knightsport ecu
- Gonna buy this turbo, just want approval from those in the know
- down pipe
- Changing the belts
- Exhaust gasket question
- Single tub assistance again please
- Injectors
- Anyone with a HKS RS induction kit and BOV fitted ?
- My Shiney Engine is Back together
- Who's using nitrous ???
- Wastegate Actuator
- Clutch & Bearing Problem? Help!
- anyone fiited a greddy boost delimiter?
- Exhaust
- oil catch tank
- Water injection kits???
- Help!!!!!
- Custom Intake
- 850cc injector holder size
- Rats nest Vacuum solenoid?
- Tip failure symptoms..?
- Boost Controller
- what size of water adapter plate
- Going for reliability?
- Garages
- Lambo Doors on FD
- Bosch 044
- Rotary Engine Rebuilding Video - weekly updates
- Dual port actuator with Profec B spec II
- First Turbo not working
- Twin turbo upgrade
- Exhaust Selection NEED HELP!!!
- Power Loss
- XS-POWER IC and pipes on flea bay
- Manual Boost Controller problem - Help needed
- Oil Coolers
- Ram Induction on my T51 via Scoot bonnet.
- 95 octane what problems??
- Engine monitoring suggestions?
- How to fit a MBC ? help needed - fd3s std twins
- any good??
- Power possible from a R3 with Standard injectors.
- flexy hose clutch slave
- Can I run un-mapped with the following mods?
- possible boost prob advice pls
- FC NA Rats nest pictures?
- So.... you just bought a Rex....
- Went to a rolling road day...
- how can you tell if its ported?
- smokey
- Single or Twin piston BOV?
- Injector Cleaning?
- Won't start :flamed
- Quiet performance exhaust - Do they exist ?
- rx7 lhd to rhd
- Which plugs again!!
- PFC - Japan and USA versions
- She won't start again :(
- What boost you guys/girls running on stock twins and injectors ?
- Apexi PFC tricks
- What can I run on Apexi base map
- Decat help
- Turbos and Decat question
- Oil smells of Petrol?
- fueling and braking advice
- Cold air feed...
- Knightsport V-mount
- Whats best in terms of BOV's
- Engine Rebuild
- what sort of exhaust
- dumb ass question but engin rebuild signs an general service needs
- ceramic apex seals
- Making your engine bay look pretty
- Where can i get a Charge Cooler??
- Posts ref Alarm wire blowing engines.
- ACV removal
- which pump for a chargecooler??
- what clutch
- engine almost cuts out after changing gear??
- Greddy elbow with injector holders, AIC, 2 x550cc injectors, etc PROJECT.
- FMIC and oil cooler move...
- Epoxy for water jacket
- Re-feeding fuel pump and coils
- What to look for when fitting a AFR
- Lightening a stock flywheel
- garrett t4 advice plase
- Boost Problems
- Alarm Related Posts
- Standard Fans
- full balancing of e shaft rotors and counterweights assembled
- Bosch 040 or R33 GTR fuel pump
- Belt Size Without Air Con
- suitabality of this turbo on a unported engine?
- !!!!!help Me Please!!!!!!
- New 2 Rotor Life
- Crank but no turn
- LS1 Engine conversion
- Lumpy idle...
- Turbo to downpipe gasket? TA45
- Turbo housing sizes?
- Downpipe noise?
- fuel smell
- help please IC fitting
- help with petrol local shell closing
- Knocking after oil change
- De-cat advise needed
- Which Injectors?
- Difference between mapping a piston and rotary
- Is this manifold ok?
- Modding an LHD FD downpipe to fit RHD
- Injector sizes and ECU help :-)
- T04S Turbo
- RE-Amemiya Filter Clean or Replace
- boost gauge
- boost gauge readings in IN-Hg
- Actuator clips?
- Spool differential creation
- Wastegates and Boost Controllers
- bridge ports
- 93% Injector Duty
- Belt size after airpump removal
- fibreglass wings etc etc
- aaaaaaaaaaaa
- External wastegate
- additional injectors
- Another n00b "name that engine part" thread..
- GReddy Intercooler
- APEXI Learning Mode
- Porting questions!
- Possible Turbo Problem
- Rotary mass flow rates
- apexi induction cones
- Air Filters
- bov`s
- radiator fans cut in point
- GReddy Profec B Spec II or Apexi AVCR
- Wastegate
- Advice on Apexi Power Intake filter for single turbo?
- Rebuild in coventry area
- Just installed APEXI FC & commander
- revs high...
- spark plugs leads which ones
- spastic mastic
- Possible Clutch problems
- Bought a comannder...
- How do i tell if im running on one rotar?
- power fc for my rex
- Dropped my baby off at WGT
- A big thanks to Carl and the guys at Hayward Rotary
- Injectors & Fuel rails
- Twin Turbos - but better
- what size intercooler pipe work
- fuel pumps
- 1600cc secondary injector kit
- Injectors & BHP
- Solid corne seals
- Primary Fuel Injectors, Clean?? Recon?? Replace??
- line lock
- This is good......
- Double throttle control
- Os Giken Twin Plate Clutch
- hks twin power and harness
- Which Turbo - and what else ?
- ABS ecu location
- Apexi FC Commander with controller
- Whats this then (detonation?)
- Which race fuel for rx7 ??
- pop again
- Fitting A Downpipe
- Fitting a profec B (what size vac line)
- will these work together?
- FMIC install HELP PLEASE!!
- What size belt?
- knock only on second turbo
- where i get turbokit?
- Knock Sensor
- Lightweight fly wheels!
- Is the exhaust different on left/right hand drive cars ?
- up rated fuel pumps
- apexi and air pump questions
- problem on second turbo
- racing beat cat back
- t4 turbo
- Different Engines
- going round the bend
- RE:worx fuel rail kit
- Injectors and fuel rail!
- Intake manifolds
- aftermarket FPR and OEM rail
- Heat light flicker...
- Water Temp. Gauge
- Understanding emmision readings!
- Anyone using these plugs: B10EGV or B11EGV
- New SMIC Yippee
- what needs to be done?
- add coolant warning light